Tagsurance 2.6 Software Download Page
Tagsurance 2.6.4 Software Package [ 592 MB ]
Multilane Plugin v.1.1.0 [445 KB]
Date published: January 16th, 2023
Extract the zip and run setup.exe to install the software
The firmware has to be updated with the update tool according to the instructions in the Tagsurance 2 manual. Tagsurance 2 Software (v.2.6.4) is compatible with Tagsurance-UHF FW version 1.9.3 and Tagsurance-HF FW version 2.6.0
Release Notes
- Reference sweep uses the same carrier-before-command time that is set for the tests, e.g. Poing test. Previously TS-UHF had a fixed carrier-before-command value for the reference sweep.
- Minor bug fixes in GUI, e.g. frequency axis values when switching between HF and UHF ranges
- PragmatIC support (software version 2.6.0 ->)
- ST25TB support (software version 2.4.0 ->)
Contents of the package
- Tagsurance 2 Installer
- Tagsurance 2 GUI 2.6.4
- Tagsurance Manual 12/2022
- Tagsurance UHF Firmware 1.9.3
- Tagsurance UHF Update Tool 1.6.2
- Tagsurance HF Firmware 2.6.0
- Tagsurance HF Update Tool 1.2.1
- Test Data Analyzer 1.7.3
- FTDI/USB-RS232 adapter drivers
Requirements
- Windows 10 PC
- USB 2.0 or RS-232 (serial) -port
Tagsurance Test Data Analyzer
Tagsurance Test Data Analyzer 1.7.3 Installer [ 191 MB ]
Date published: 25-MAY-2020
Requirements
- Windows 10 PC
IO controller
Multilane IO controller v1 installer [ 265 MB ]
Specs:
- can only be used when there is one trigger for all the lanes
- if more than one lane, the lane numbers >1 are triggered “virtually”; first lane has to be triggered twice before the virtual trigger starts working
- marker signal is up as long as the test takes (goes up on Nth trig – configurable offset – and down when the test started on that trig ends)
Printer signalling
- if tag failed the test, print signal is set to float (otherwise grounded) when the Nth tag causes trigger (N is the offset for bad tag marking)
- print signal goes down (is reset) when the test triggered is completed
- for a passed tag the printer signal is kept down